Since the DC has a Tach, many think you need an encoder on an extruder.  The reality is the speed regulation on Open Loop Vector systems are twice that of DC!  Unless you are extruding medical tubing or ultra-fine sheet, the addition of an encoder is unnecessary;  moreover, sometimes the addition of an encoder results in the extruder fighting itself. 

  • Smaller, More Compact Design, Can Fit Under Barrels

  • Smaller than DC Motors, No Trenching into the Base

  • In Open Loop Vector, Gives Twice the Speed Regulation of DC with a Tach

  • Better Insulation than most Inverter Rated Motors

  • Feels Hotter to the Touch Because of Better Cooling Methods

  • 1:1000 Speed Ratio for Full Torque at Lower Speeds

  • Premium H Class Insulation for High Temperature Operation

  • 10-15% More Energy Efficient than DC Motors

  • 100, 150, 200, 300 AND 500 HP MOTORS IN STOCK!

RPMAC MOTORS

LAMINATED FRAME

ENCODERS ON EXTRUDERS?

NO

RPMAC MOTORS

LAMINATED FRAME

  • Smaller, More Compact Design, Can Fit Under Barrels

  • Smaller than DC Motors, No Trenching into the Base

  • In Open Loop Vector, Gives Twice the Speed Regulation of DC with a Tach

  • Better Insulation than most Inverter Rated Motors

  • Feels Hotter to the Touch Because of Better Cooling Methods

  • 1:1000 Speed Ratio for Full Torque at Lower Speeds

  • Premium H Class Insulation for High Temperature Operation

  • 10-15% More Energy Efficient than DC Motors

  • 100, 150, 200, 300 AND 500 HP MOTORS IN STOCK!

BLOWERS

The standard Inverter rated motor without a blower is designed with a fan on the back that cools the motor when running full speed...FULL SPEED, not slower!  Not only is the insulation class typically lower, but the cooling characteristics are not designed for extrusion...and they are just too darn big!  The blower is needed for cooling and is always included with the filter kit on ICT's pricing.

PLASTIC MACHINERY

CALL US   +1.9729067445

​Extrusion Line upgrades

OK...so we photoshopped this image...

​Extrusion Line upgrades